How do I remove a Z-wave device from a Devicebook Smart Home?

You can remove a Z-Wave device using House Check in the Devicebook App. 

1. In House Check, find the device you want to remove.

2. Tap the "Reset" button for the device.

You will be prompted to unpair the device. It is recommended to always unpair the Z-Wave device to properly remove it. Follow the instructions to unpair the device, and then Devicebook will remove the device from the smart home.

 

 

Note: It is strongly advised that you do not reset a Z-Wave device to factory defaults while it is paired to the Devicebook Hub. Doing so could result in Z-Wave network communication issues for all other devices on the network.

Instead, you should unpair the Z-wave device from the Devicebook Hub.

Articles in this section

Was this article helpful?
0 out of 0 found this helpful

Comments

0 comments

Article is closed for comments.